SHARC Saw Parts for Amada Bandsaws
SHARC Guides to Fit Amada® 530 Model Bandsaws using a 2.625" Blade
Cost # NC530A
complete set of 4 guides.
Proudly Made
In the U.S.A.
Cost: # NC530ASBU
complete back up guides as shown.
Significant characteristics:
These guides were created by customer request. Under extreme use, the factory backup carbide strip is not wide enough to contain the blade movement. During operation the blade would walk off of the strip and cut into the holder body. Once cutting began, the expensive carbide blade on the machine lasted only minutes. With SHARC Super Backups for your 530, this will no longer be an issue. The carbide is wide enough to accomodate any blade movement and it is brazed in for security. Guides are shipped complete with rubber isolaters installed.
Back to SHARC Guides for Amada Saws Main Page
Back up Guides Shown Below
All Blade Guides
Guide Kit # NC530A Replaces these
O.E.M. Part #'s
1) 1203507b
2) 1203508b
3) 1203513
4) 1203514
NC530A Rear view
pair of 2 Back up strips and 2 Rubber Pads as shown. This kit is for the standard OEM backup
holders.
Cost: # A-530-BU
Sharc Part # NC530ASBU
Sharc Part # NC530ASBU
Alternate View
NC530A Rear view
Alternate View
Sharc Part # NC530A
Sharc Part # 530BU
Home
Fresh
Catches
Online
Catalog
Service
Remanufacturing
Information
Company
Place Your Order Now at 440-377-5657
Place Your Order Now at 440-377-5657
Contact
Information